Markel Hazardous Location Convector 12286 BTU 3600 Watt 208V 1 Phase FEP-3620-1RA
The product Build Time you see represented on this site is only a typical number of days the manufacturer states it needs to build the product(s) when ordered. Build times are based on business days (excludes weekends & holidays).
The build time does not include the time it will take to ship the order to you (the customer). If an order has multiple items and comes from multiple warehouses, you may receive part of your order on one day, and then receive the remaining part(s) of your order at a later date.
*Please be aware that seasonal demand of certain equipment may cause build times to run longer than what is typical.
*This Unit Is Custom Built and Will Be Final Sale
T-2A Series Single Phase
These hazardous location heaters have been designed for installation in areas where potentially explosive, flammable vapors may be in the atmosphere, but a comfortable range of heat is maintained and desired.
-Suitable for both Division 1 and 2 locations.
-Approved for the following Class 1 groups:
Group B: Atmospheres containing hydrogen, fuel and combustible process gases containing more than 30% hydrogen by volume, or gases or vapors of equivalent hazard such as butadiene, ethylene oxice, propylene oxide, and acrolein.
Group C: Atmospheres such as ethyl ether, ethylene, or gases or vapors of equivalent hazard.
Group D: Atmospheres such as acetone, ammonia, benzene, butane, cyclopropane, ethanol, gasoline, hexane, methanol, methane, natural gas, naphtha, propane, or gases or vapors of equivalent hazard.
-Temperature Code: Do not install in areas where vapors or gases having an ignition temperature less than 280C (536F) for T-2A models, and 180C (356F) for T-3A models.
For additional information on Div. Class and Groups, refer to NEC Article 500 HAZARDOUS (CLASSIFIED) LOCATIONS.
Cabinet size 18” high, 9” wide
Air Flow; Bottom In - Top Out
Wall mounting bracket supplied
Units cannot be operated in room ambients exceeding 104°F (40°C)
Heavy duty 16-gauge steel with gray epoxy textured powder coated finish
9” minimum clearance from bottom of heater to floor required
Stainless steel cartridge element inserted into Aluminum finned Copper sheath
Standard unit (without EPET thermostat or control section) is NEMA 4 rated
Made in U.S.A.
- Model No.:
- Made In U.S.A.:
- Dimension Inches:
- Width: 34" Depth: 9" Height: 18"
- Limited Warranty:
- 1 Year Limited
- Watts High:
- Weight lbs.:
Notice: Manufacturer's products features and specifications are subject to change without notice.
California Residents: WARNING- This product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, please visit www.P65Warnings.ca.gov.
QUESTIONS & ANSWERS
Have a Question?
Be the first to ask a question about this.