Stationary Dust Collector & Fume Exhauster 375 CFM w/ 4 inch x 10 ft. Hose 32110-043
This low-cost fume exhauster is not only ideally suited for collecting smoke and fumes from all welding, brazing and soldering operations; it is necessary for the good health of your employees. Industry has come to recognize the importance of good ventilation of fumes from the above operations. The fumes emitted from welding certain raw metals and coated metals such as galvanized, are not only a nuisance but a hazard to the health of the welders.
The Model FC draws these fumes away at their source and exhausts them to the outside. This assures both the comfort and the health of the welder and cuts down on fatigue. This unit, because it traps the fumes at their source, eliminates the need for additional high-volume ventilation units which increase heating expenses in the winter months.
FEATURES
Highly efficient cast aluminum and steel plate blowers
10 feet of 4" flex hose
Fume hood
Adjustable discharge elbow
Rubber vibration mount
Non-sparking aluminum construction
- Model No.:
- 32110 -043
- Voltage:
- 230
- Warehouse:
- Ohio
- Type:
- Fume Extractors
- CFM High:
- 375
- Construction:
- Cast Aluminum
- Dimension Inches:
- Width: 12.5" Depth: 19.3125" Height: 12.875"
- Horsepower:
- 1/3
- Limited Warranty:
- 2 Year Limited
- Motor Type:
- TEFC
- RPM High:
- 3450
- Phase:
- 1
- Weight lbs.:
- 55
-
Notice: Manufacturer's products features and specifications are subject to change without notice.
-
California Residents: WARNING- This product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, please visit www.P65Warnings.ca.gov.
QUESTIONS & ANSWERS
Ask a Question-
I have a work bench where i fix commercial vacuums, and i need to exhaust all of the dust and dirt that comes from my vacs. It is just one workbench, and im trying to decide how much cfm i actually need for it to suck up lots of dust and dirt. Not sure if you can answer this but i will give it a shot! Thanks
It would be difficult to say the CFM required. This fume and dust collector works well when the hood is placed close in proximaty to the work causing fumes / dust.